Whirlpool Dryers Not Starting: How to Fix It Yourself
When your Whirlpool Dryer won't turn on, it's usually something simple — a power issue, a tripped safety switch, or a connection problem. Before panicking, work through these steps. Most of the time, the fix is free.
⚠️ Safety First
- Unplug the dryer before working on it.
- If you have a gas dryer, turn off the gas supply line first.
- Let the dryer cool for 30 minutes before working inside it.
Parts You May Need
Step-by-Step Repair
- 1
Check the power source
Make sure the outlet is working by plugging in something else (like a lamp). Check if the power cord is fully plugged in at both ends. For battery-powered devices, make sure the battery is charged and properly seated.
- 2
Look for a reset button
Many devices have a small reset button (often red or recessed). Check the bottom, back, or side of your dryer. Press it firmly. If it clicks, that may have been the problem.
- 3
Check the circuit breaker or fuse
Go to your electrical panel and check if any breakers have tripped (they'll be in a middle position). Flip any tripped breakers fully off, then back on. For plug-in fuses, check if they need replacement.
- 4
Try a full power cycle
Unplug the device completely. Wait 2-3 minutes. While unplugged, press and hold the power button for 30 seconds (this drains residual power). Plug it back in and try again.
- 5
Inspect the power cord and connections
Look for frayed wires, bent prongs, loose connections, or burn marks on the plug. A damaged power cord is a common and inexpensive fix ($10-$20 for most replacement cords).
- 6
Test with a different outlet or power source
Plug the device into a completely different outlet, preferably on a different circuit in your home. If it works on a different outlet, the problem is with your home's electrical, not the device.
If That Didn't Work
- A clogged lint vent is the #1 cause of dryer problems — clean it first.
- The cycling thermostat may be faulty.
- On gas dryers, the gas valve solenoids may need replacement.
When to Call a Professional
If you have a gas dryer and aren't comfortable working near gas connections, call a professional. If basic parts replacement doesn't fix it, the control board may be faulty ($100-$200 for parts and labor).
Related Repairs
Disclaimer: This guide is for informational and educational purposes only and does not constitute professional repair advice. All repairs are performed at your own risk. RepairItFree.com is not liable for any personal injury, property damage, device damage, voided warranties, or other losses resulting from the use of this information.
If you are unsure about any step — especially anything involving electricity, gas, water, or refrigerant — stop and consult a qualified professional. Your safety is more important than saving money.
See our full Terms of Service for complete legal details.